![]() That means the assets will not be fixed in place until you click on the Confirm Placement button. Once a surface for asset placement has been identified click on that highlighted surface and proxy models of the selected assets will be placed on that surface as a preview. Hovering the mouse around in the Enscape Viewport when the Bucket Selection tool is selected will show a bucket symbol instead of the the mouse pointer and any surfaces that are available for asset placement will be highlighted as you hover over them. The Bucket Selection tool will place assets on to an available surface. Click Apply Changes when you are done placing assets to load the full geometry and textures and allow for individual asset editing. You can continue to adjust the size and position of the circular area by clicking and dragging the respective orange control points.Īs with the Rectangular Selection tool click on Confirm Placement to continue creating other areas. Once specified, asset proxy models will appear within the defined circular area. The second control point will follow the mouse movement to allow the user to specify the initial diameter of the circular area. ![]() The control point at the center of the circular area specifies the pivot point or the center of the circular area. Two control points will then become available. Similarly, to the Circular Selection tool, a allow you to specify a circular area of a surface for a selection of multiple assets to be placed on.Īs with the Rectangular Selection option, the first click will specify the point that will be the center of the circular selection. If you want to start placement again, click on the Discard All button. Only after you click on the Apply Changes button will the full asset geometry and the associated asset textures be placed in the project.Īt that point the individual assets will be available for individual editing or deletion. Once Confirm Placement has been clicked, you can continue to specify other selection areas using any of the 3 selection tools. You can continue to make adjustments up until you click on the Confirm Placement button. The assets will be recalculated and regenerated to accommodate changes made to the selection area. ![]() You can continue to adjust the size of the rectangle by clicking on either of the 2 orange control points which will allow you to adjust the rectangle’s orientation and size. You can increase the width of the rectangle at any point during this process by adjusting the Width slider located below the 3 selection tools. When you finally click to specify the length of the rectangular area some proxy assets will appear within that specified area. One control point will anchor itself to the surface to act as a pivot point and the other control point will follow the mouse movement to specify the length of the rectangle. Once you have clicked on the surface to specify that origin, 2 orange control points will appear. Once selected, by moving the mouse over a surface in the Enscape Viewport the user will see a circle with a control point in the middle to assist in choosing the origin of the rectangular area to be specified. Selecting the Rectangular Selection option provides a way to stipulate a limited area the assets will be placed in. NOTE: If you find the Asset Library window, or the Enscape Viewport is blocked by a notification stating that no seats are available on the current License Key, or that the License has expired, then please refer to this article. This article focuses on the initial placement of assets via both methods and begins with explaining the tools available in the Enscape Viewport UI, followed by the placement methods available in SketchUp. But, once an asset has been placed, it then becomes available to be edited using the tools accessed via Asset Library when opened from within the Enscape Viewport UI. The Asset Library dialog that is opened via the CAD toolbar only allows for basic Single Asset Placement. This feature is available for both Enscape and Custom Assets, but the complete feature is only available when the Asset Library is opened via the Enscape Viewport UI. ![]() This is covered in more detail in this article. Either from within the CAD toolbar or from within the Enscape Viewport User Interface (UI) toolbar. Asset Placement is achieved via the Enscape Asset Library which can be accessed in one of two ways.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |